Two newly installed Juniper routers overloaded FAA network and halted US flights
The fault was traced to a router feature now disabled across the network, but the FAA has not yet ruled out installation or configuration as causes.

A nationwide FAA ground stop on a Friday night was triggered when newly installed routers at two FAA sites, one in El Dorado, Arkansas and one in Amarillo, Texas, began flooding the agency's aging copper communications network with traffic. The first symptom appeared at Indianapolis Center, where controllers lost contact with flight crews. Engineers traced the overload to a specific router feature, and FAA staff disabled it on all Juniper routers across the network, restoring normal communications after roughly four hours. HPE said its equipment was working as designed and had not failed. The FAA is investigating whether the cause was installation, configuration or the hardware itself, and the disruption is expected to leave travelers facing delays of hours to a couple of days. The episode also highlights the cost of the ongoing, multibillion-dollar move from copper to fiber.
Why it matters
The outage shows how a single misbehaving component can disrupt air traffic nationwide when the underlying communications network is outdated. It also puts the cost of the FAA's shift from copper to fiber into sharper focus, since the aging copper network was the system overwhelmed. Passengers face delays while the agency investigates whether the equipment, its installation or its configuration was responsible.
Series FAA nationwide ground stop
- A faulty router upgrade knocked out US air traffic control and forced a nationwide ground stop
- Two newly installed Juniper routers overloaded FAA network and halted US flights
- Routine FAA equipment upgrade blamed for nationwide US flight ground stop
- FAA Ground Stop Halts US Departures After Communications Failure
Matters or hype?
Does this story matter, or is it hype? Vote before you see what everyone else said.